| Reset Time | On Delay/Interval/Repeat Cycle/Delayed Interval: 0.1 Seconds, Off Delay/Single Shot/Watchdog/Triggered Delayed Interval: 0.04 Seconds |
| Temperature | 12-120V Input Voltage: -28° to 65°C (-18° to 150°F) � 240V Input Voltage: -28° to 50°C (-18° to 122°F) |
| Voltage Tolerance | AC Operation: +10/-15% of nominal at 50/60 Hz. � DC Operation: +10/-15% of nominal. |
| Output Current | 10 Amp |
| Setting Accuracy | Maximum Setting (Adjustable): +5%, -0% � Minimum Setting (Adjustable): +0%, -50% |
| Start-up Time | (Time from when power is applied until unit is timing) 120 & 240V units 0.05 Seconds � 12, 24 & 48V units 0.08 Seconds |
| Input Voltage | 24 VAC/VDC |
| Mounting | 8 Pin Octal |
| Function | Interval On |
| Repeat Accuracy (constant voltage and temperature) | > 2 Seconds Delay +0.1% � 0.1 - 2 Seconds Delay +2% |
| Type | Single Knob Unit |
| Maintain Function Time | (Time unit continues to time after power is removed) 0.01 Seconds for all units |
| Contact Configuration | 2C DPDT |
| Load (Burden) | 2 VA |
| Function Description | INTERVAL ON |
| Sub Category | Interval |
| Life | Mechanical: 10,000,000 operations � Full Load: 100,000 operations |
| Insulation Voltage | 2,000 volts |
| Main Category | Time Delay Relay |
| Timing Range | 0.1 sec - 120 min |
| Compatibility | On all units triggered by input voltage or by a control switch, do not use a solid state switch to initiate the timing sequenceproblems with leakage current could occur. On all units with a power trigger, do not use a solid state switch with leakage curre |
| Triggering Off Delay, Single Shot or Watchdog Units | Timing sequence must be initiated only after input voltage is applied to unit. Minimum required trigger switch closure time is 0.1 seconds. |
| Output Contacts | DPDT 10A @ 240V AC/28V DC, 1/2HP @ 240V AC, 1/3HP @ 120V AC B300 & R300; AC15 & DC13 |
